Tuesday, 7 October 2014

Animated Vertical forum set


This tutorial was written by Mizteeque on 16th June 2014
written in psp9 but any version should work
any similarities to other works is purely coincidental

Supplies Needed:

Tube of choice, I am using the gorgeous artwork of Very Many
you can purchase this tube here http://verymanytubes.com/
Font of choice
Filters:  Xenofex 2 - Constellation


Lets begin!!

NOTE: c/p = copy and paste as new layer

Open blank canvas 200 x 700

1.  set foreground to light colour from your tube
set background to dark colour from your tube
then set foreground to gradient, linear, angle 45, repeats 4
floodfill with gradient

2.  c/p tube as new layer
adjust, blur, radial blur,
twirl checked
strength 100
twirl degrees 61
elliptical checked
horizontal/vertical offset 0
protect center 0

3.  position so the middle of your twirl is in the center of your tag
change blend mode to luminance legacy

4.  duplicate this layer twice for a total of 3 layers
close off top two, make bottom one active

5.  magic wand, tolerance 5, feather 0
click around your tag in several places

Xenofex 2, constellation with following settings

Keep selected
make middle layer active
repeat constellation, but click random seed
and again for the top layer


6.  c/p tube as new layer
lower opacity to around 36

7.  new raster layer
select all, contract by 3, invert
floodfill with your gradient from earlier
adjust, add noise, Gaussian, Monochrome checked, 100

8.  Add name and copyright information

Now to animate

9.  close off top two sparkle layers, copy merged
paste as new animation in animation shop

10.  back to psp, close bottom sparkle layer, open middle sparkle layer, copy merged
paste afer current frame in AS

11. back to psp, close middle sparkle layer, open top sparkle layer, copy merged
paste after current frame in AS

12.  Save as gif

If you would like to make a matching avatar go back to psp

selection tool
custom selection, left & top 5, right & bottom 185
copy merged
paste as new image

close top sparkle layer, open middle
copy merged
paste as new layer on new image

close middle sparkle layer, open bottom
copy merged
paste as new layer on new image

Add border as we did for the tag
add name and copyright
and repeat steps 9 - 12

thank you for trying my tutorial xx

No comments:

Post a Comment